Recent content by Rainking79

Yeah mate. Down into the bathroom below. Idea was you’d be in the shower and could look up at the sky. Tranquil like :D

I'm really not sure my roof has any of that, apart from maybe the longitudal bracing. I'll need to take another look. Its a shallow pitch, stuffed with insulation, so a pure pain to get into to :D Appreciate your help Woody (y)

In my defense, I did mention in the OP it was a fink. In my ignorance, I wouldn't know what difference it would make :D

I thought top of a truss was a rafter (?) I need to remove the short diagonal on one truss, to make the space on the roof. I don't have anything built in specifically for that being removed, if that's what you mean. Are you thinking like putting in a vertical support (below)? Really don't...

I've attached my effort. I didnt do a drawing for the double-header installation as I ran out for motivation by then :D Hoping to get it submitted tomorrow with fingers crossed. All comments welcome/encouraged :)

:LOL::LOL::LOL:

Awesome - thanks Woody. This is exactly what I had in mind, so could submit this as is :D :D I'll share my version, for posterity and any feedback :)

This would be the dream but unfortunately I don't believe we do. Guidance on needing warrant says "If you're not sure whether you need to apply for a Building Warrant you can ask your local council's Building Standards service.". They replied to me with "Unfortunately, due to the many...

I’ve spent most the of the night trying to learn what i need in Sketchup. I’ve got a set of trusses at 600c, so marginal gains :D Just going to need to take my best punt on the warrant and hope for the best. If anyone has BW samples they could share it would be most appreciated.

I've been (unsuccessfully) trying to obtain the services of a SE for the above work - I, perhaps mistakenly, thought they could do the drawings with the necessary reinforcements required. The last two have mentioned they'd need an architects drawings, even if they had the time to help me. Can...

Very true! :) They are 34mm x 67mm (70's build).

Hi all, im planning on installing a Velux but need to submit plans for a Building Warrant (Scotland). I'd need to cut one rafter to create the space needed in the roof plus one bottom rafter (to flow into downstairs bathroom). Has anyone submitted plans for this work before they could share...

Ok, been sleeping on this. Went to bed feeling it was cracked then woke up thinking 'no, thats not right' :D So, where I need the appliances is between two sockets (~3m apart) in the ring. If im thinking about this right, I need to take two spurs to DP switches between these sockets. Is putting...

Yeah mate - ring looks to be on 30 amp fuse (with the red dots in the pic). The more I think about it the more im convicing myself a re-wire is the 'easiest' thing... There could be a 3m cable span between two sockets in the ring - is that 'kosher'? Im guessing its there just now - if im...

Feels like a DW and WM would burst that 15amp if they happen to be running a 'hot' cycle at the same time, which puts me back to the start.... A re-wire wasnt on my list for this but looking around the kitchen it could be doable meaning I could extend the ring to include the two new sockets...