Recent content by RedHue

I've had our gas fire removed and gas feed capped (by a gas safe engineer) and have now stripped the mantel/hearth etc out. I've taken all the firebox boards off the back and sides to get back to the breeze block to install an external air brick for ventilation. Do I need to do anything at the...

Didn't even think about that - it's currently set to N/C, is it Double Pole/EOL I need or the resistor values?

Perfect, thank you. I've bought the EOL PA button which should be here next week. To confirm the tamper wiring, I'm simply removing the PA button tamper wiring from the block and leaving the rest in series (similar to this from another post)? Then with the new PA button, wire in the blue and...

Thanks. I checked out the configuration further - both the tamper and PA pressed alarm as Zone 7 Active. I've attached a picture of the panel wiring which shows all of the green/yellow tamper wire being terminated in a terminal strip. Am I able to change the tamper configuration easily enough...

I currently have an old alarm panic alarm button that the casing has been damaged as part of renovating the room which I now need to replace. The panel is a Texecom Premier Elite 24 with the PA on its own zone and wired with a 4 core cable (picture attached). Can I replace this with an EOL PA...