Hi all
I'm planning to sort out my back yard by laying some nice stone or slate paving but need som advice on how to actually do it. At the moment it's 70% concrete and 30% gravel (with mud under it) and has 2 or 3 drain covers. My questions are:
- how do i smash out the concrete without...
Got thome and had a look - the pipe was a little deformed and the olive was on way too tight to get off so I cut the pipe below the olive and fitted the new olive, reassembled the valve and it was fine.
Only thing was i found impossible to get the new 8mm olive and nut on to to 8mm pipe. I...
Thanks for the quick response!
OK that all sounds good, just one more question... if i take the lockshield valve off and the pipework looks OK should i just buy a new valve or should i just put some tape on it and refit (got a new olive so will put that in anyway)
Can't find a specific answer to this so wondered what my options are...
[I have a sealed system with a baxi ecotech combi boiler ]
I've taken off two radiators in my front room whilst decorating and then noticed I had a small leak at the lockshield valve where the copper pipe attaches to...
thanks for all of the advice - some of which was helpful and some of which was patronising...
The problem has now been professionally diagnosed and fixed... The tank (indirect double feed coil Fortic F4) was badly limescaled up and forcing pressure back down into the bolier, this coupled...
Hi All
Hope somebody can help me out here because i can't afford this to happen again or even worse buy a new boiler....
I have two problems here:
A) 3 years ago the heat exchange on my Baxi Bermuda Inset 2 (50 / 4) back boiler craked and leaked all over the front room floor. I got this...