Yeah all works ok on battery and on the mains just want to sort out the flashing mains led never done it over the last six years strange ive even disconnected all the power mains/batt to try reset but no difference
The mains led is flashing on the two remote keypads front and back door
But...
Melcom st6500 alarm
The green power led has started to flash about every
3seconds its never done if before.
Ive metered continuity on all internal fuses all ok
The back up battery is about 3 months old and giving out 12v
Everything all looks ok inside the control panel
Ive check...
Ive just purchased a texecom cga-0001 speech dialler to connect to my alarm
I've connect the power from alarm to dialler
Connected the phone line
And a wire from bell- to trigger 1
When I check the dial setting it ring through to the number set in the dialler
But when I trigger the...
It was new in box but no manual I will try leavin it on it the morn to see if it charges the nicad wen u say fit the 1k resistors do u mean from the 13v connection to the bell+ and same to the strobe+
I really appreciate ur help this is doin my head in
Havnt got manual and cant find a manual on the net in the bellbox theres a resistor taped to the cover called a pull up resistor any ideas where it goes shound stop the bleeping
Has anyone got a manual or a link for a CQR SIGMA bellbox manual thanks in advance
Hi sparkymarka
Wired bellbox up like u said but bellbox continues to bleep
But then i removed the cover/tamper screw and stopped bleeping but then control panel siren went off and tamper led on
Any ideas
Hi sparkymarka
Wired bellbox up like u said but bellbox continues to bleep
But then i removed the cover/tamper screw and stopped bleeping but then control panel siren went off and tamper led on
Any ideas
Trying to wire bell box to control panel
Can anyone help
Sigma Bell box. Terminal.
Set
Bell
Stb
Tmp
- hold off
+ hold off
Nc
Battery - goes to battery pack in bellbox
Battery +goes to battery pack in bellbox
Optima g3 control panel terminals
+ strobe
- strobe...