Recent content by Rms1

That’s great. Thank you

Hi, Replacing a utility room sink. The sink waste hole is in a different place to the previous sink. Attached image shows existing waste pipe and where the sink waste will roughly be. Wondering whether it can be connected via a flexible waste pipe? If so, is it a male and and a female thread...

Hi, Freestanding bath is gurgling when the sink tap is emptied. The pipes are not blocked. Although the noise is slightly annoying, will the gurgling cause any problems in the long run if it is not resolved? Thanks

We had a Worcester Bosch greenslave Combi (oil) fitted approx 3 months ago. A noise is radiating from within the radiators when the hot water is on, and also when the boiler is warming the small tank within the boiler. The installer cannot identify why this is happening, and hopes it might stop...

Thanks very much :)

Can I just check, I think there are flow ways at the top and bottom of each panel? Do I tap both? Thanks

Thanks for this idea, will try it tomorrow

Hi, thanks yes sorry I meant height. I believe it was installed in 2009/2010, we moved into the house in 2014. I am not sure if it worked when we moved in. Rachel

Hi, The radiator is 44cm wide by 180cm length. 3 out of 6 panels are not heating up. From left to right, the panels remaining cold are panels 2,3 and 6. I am presuming that the holes are blocked or rusted over (have bled radiator etc and nothing has worked). Is the easiest solution a new...

Hi Yesterday I had a new integrated dishwasher fitted. After they had left I noticed the top drawers on the cabinets either side were slightly sticking out. The drawers close fully but they are not flush with the cupboards which are beneath the drawers. The installers have been back today...

Just used pliers which worked. Thanks very much!

Hi Our boiler has low pressure. Am trying to increase the pressure but cannot work out how to release the valve on the filling loop as there is no handle. Hopefully a picture is attached. I presume I need a tool? Thanks for any advice.

Thanks John, I will try that in the morning....

The drum pulley doesn't have grooves. The washing machine is located in the garage where the light isn't that good so I could take a pic in daylight tomorrow. I have been doing a bit more research in the last hour and have a horrible feeling it could be the bearings... Will try and take...

Hi John It is a multi grooved belt. The motor is wider than the belt so I placed the belt in the middle. Perhaps I gave aligned it incorrectly? Thanks Rachel