Recent content by robg47

Thanks both. Just so that I am clear, one IN/UT pair should use the Live Supply and the Live Load whilst the second IN/UT pair should use the Neutral Supply and the Neutral Load. Trouble is, the switch doesn't indicate which pair should be Live and which pair should be Neutral!

I recently purchased an Immersion Heater Switch on ebay with no instructions. It appears to have been made in Sweden and has 2 sets of conntacts both with IN and UT on them (plus 2 earth contacts). I'd be grateful if anyone could tell me whether IN means Live and UT means Neutral or whether IN...

The pump was put in with the word GRUNDFLOSS the right way up and with the direction arrow pointing upwards in a vertical manner (same as the previous pump). Also, the lower end of the pump being connected to the pipe coming from the bottom of the Boiler. I have bled the pump and checked that...

I have a 25 year old Ideal Standard conventional boiler and recently the pump went. I replaced the pump with a GRUNFOS 15/60 pump and the new pump appears to be working fine. However, the pipes into/outof the boiler, all radiators and also hot water are never more than lukewarm even when the...

Thanks ChrisR. Re-drained system, made sure to bleed all rads, pump etc, system now working A1 !

I have a 25 year old Ideal Standard conventional boiler and recently the pump went. I replaced the pump with a GRUNFOS 15/60 pump and since then the pipes into the boiler, all radiators and also hot water are never more than lukewarm even when the room thermostat and the boiler hot water...