Recent content by rockguitar10

Hey. It’s the Triton Aspirante (Collections 2) - the black gloss one.

Hi, Please help. Hopefully you can see from the pictures that the water is leaking from the part of the valve that is turned by the temperature control knob on the outside. Is this a common problem? Is there a seal inside that can be replaced or should I replace the entire solenoid assembly...

Anyone?

Hi, I have a Worcester Bosch MT10RF Thermostat which has the day and night settings. I have just moved into a this house and thought it was pretty easy to operate until the heating came on and went off at times that we had not set! What I have noticed is that the time setting outer ring...

Hi. No play in the inner drum. Where is the filter? Can't see anything at the front or the back!

Yes, a little but it's stiff to pull it up. There is a great amount of play in the drum forwards and backwards.

Hi, My Hotpoint Aquarius Washer/Dryer is clunking when the drum is moving. When i turn the drum by hand or use the belt at the back it still clunks at pretty much the same point whether i spin it slow or fast! I can't see any obstructions at the back or inside the drum. I also removed...

Looks like that was it! I had an electric heater in that hall until 7pm lats night when the radiator finally heated up! Left the heater on at low setting during the night just in case as it was cold again (and it'll be as low as -10 by Thursday up here!). Thanks again for your help!

Thanks - I'll give it a try and see how we go!

Hi, The radiator in my hall (very small hall at front door) is a single radiator and was freezing cold this morning when I got up. The other radiators heated up ok. I though that there might have been a blockage or the pipes had frozen but I bled the radiator with about a litre or so of...

Hi, I have a sealed combi boiler system and think there is sludge in the downstairs radiators as they ain't very warm but upstairs are very warm - I have roughly balanced the radiators but the owner had a new boiler installed on the cheap a year ago and I doubt they cleaned the system (or did...

Thanks guys. If i'm reading it right (and there's no guarantees!) this applies to radiators with only Lock Shield valves - 4 of my 6 radiators are 'double' radiators and are fitted with TRV's - is this still the way to go?

Final update! I had the Halstead engineer out as the boiler was still under warranty and he replaced the PRV and recharged the expansion vessel. He also laughed at condemning the boiler (this was a supposed friend-of-a-friend plumber looking for work!). The pressure was still dropping and...

Hi, I have just replaced the valves on my radiators as 3 of the 6 were weeping causing slight loss of pressure. Since then I have had the boiler engineer out (Halstead Ace High boiler) and he replaced the PRV and 'recharged' the expansion vessel. We were still losing pressure but it...

Update: Boiler has been installed by cowboys! Problem with expansion vessel; flue has been installed at an angle (to avoid pipes on it's way through the wall) and two pieces of pipe have been used (secured with silver tape!!!). There are various other problems with it. So........the...