Thanks for that @EFLImpudence - 15 seconds of my life I’ll never get back. The two bottom right terminals are marked “neutral” and “earth” respectively. I’m not simply just assuming but I get your point. I’m simply just looking for someone who’s had a similar set up. All the other T9000 posts...
Definitely sounds like heat ex is leaking. Wouldn’t in a million years be recommending buying second hand heat exchanger though. I’d just bite the bullet and get it replaced by Gas Safe Registered engineer. Think you’ve just had a bit of bad luck at a bad time!
Hi Sartob. It sounds to me like the person who installed your cylinder hasn’t aired the system properly when draining the system then refilling it upon completion. My best advice would be to turn every radiator off (turn thermostats down to 0 on one side, remove lock shield cover and use a...
Hi. I’m wondering if someone can help me. I am trying to swap out a Danfoss TP9000 for a Hive (image below). I have done as follows;
Neutrals - Neutrals
Live - Live
3 - 3 (HW On)
4 - 4 (CH On)
5 (Removed at Timer and Sensor)
6 (Removed at Timer and Sensor)
Extra Neutrals? (Bottom right of...
@stem
Spot on mate. Followed that step by step and worked perfect. Couldn’t find the other end of the old receiver at the junction box but all sorted. Thanks a lot for your help!
I’ve just purchased Hive and after reading instructions am a bit dazzled as to the wiring for an old WR1 receiver and UP2 programmer. Can anyone explain how I link out either the timer/receiver? There is also a wireless room stat but I’m guessing just decommission by removing the batteries. Any...