Recent content by sajeel

Depends on how old sink is and the main goal is to be able to pass space for two pipes if the original bracket cant be used then then the shank and bolt can be used and the plate and rubber may require modification an angle grinder can trim plate and you can cut rubber seal with knife in worst...

Tony have you gone quiet or did you choke on some gas

Get USB Type A to Type B cable, plug A into PC, completely power down mains and battery, plug B into panel, turn on, panel will identify to PC as a different device to usual (i.e with power already on before connecting USB) Run software, follow instructions.

rather than moaning why dont use post the correct one

not a problem glad to be of help

Haha very funny, i use joint compound something like water hark which is wras approved will be sufficient

that is another option go to fully pumped system

great hope you get sorted hopefully an air vent will bleed system and you will have hot water back, some pics may be helpful

hi, 1) install tap blank like this http://www.screwfix.com/p/tap-hole-stopper-chrome-plated/40626 Then use this to mixer tap http://www.screwfix.com/p/flexible-tap-tails-10mm-x-15mm-x-300mm-2-pack/4565g Purchase mixer tap and all done . 2) not impossible but complicated as you would need to...

In that case the boiler will be heating the tank you should have immersion heater as a backup ?

you need to ensure diverter valve is working the fact that heating is working would indicate the diverter valve is not working

was just a guide

http://www.texe.com/uk/uploads/INS552-3_Premier_Elite_Flasher_Instructions.pdf

30kw x 12p = £3.60 if your meter is metric not cubic that sounds about right depending on size of property with regards to your hot water you need a 2 channel timer something like this should do...

thanks for pics what plywood thickness did you use ? and did you put staggered nogs ? The creak is due to movement so you need to locate and secure by either adding more nogs using thicker ply or more screws you could also another thin sheet of ply on top of current floor with longer screws to...