Recent content by Savo09

  1. S

    cylinder only partially heating at the top

    around 10 litres of hot water! and oil fired boiler working of a one channel time clock. not being a plumber im not well educated on the subject but it appears that the ch heating doesnt warm up the water in the cylinder as well as it used to before the extra rads were installed. from all...
  2. S

    cylinder only partially heating at the top

    the hot water cylinder is fed through the bottom via an external immersion heater. the immersion was on for around 45 mins but the water in the cylinder was only hot about an 1/8 of the way down from the top! when running the hot water tap the water ran hot for around two mins and runs cold, as...
  3. S

    cylinder only partially heating at the top

    Its a external water heater! Would it be possible to replace the element or would it make more sense to replace the entire unit? How much would one cost roughly?
  4. S

    cylinder only partially heating at the top

    Had the immersion heater on for around 45 mins. Appears that only the top 10cms of the cylinder had heated. The immersion feels warm but not scadling. The water from the hot tap ran cold after 2 mins. Would it be possible that the element in the heater has gone? Any one with any ideas...
Back
Top