Obviously the supplies shop is closed today. What would you expect to happen if I (temporarily) short the interruptor in the TC? Would this prove the above problem - I have tried this & the heater still shuts down after a minute or so!
I had a spare (new) thermocouple & replaced this straight away. With the boiler switched off (unplugged) the pilot stays on, so I assume the thermocouple is working OK. The pilot does go out the same time as the boiler closes down (with a loud click). I thought that this was due to the overheat...
Top of boiler gets very hot before it switches off.
I can feel hot water in the pipework around the Pump & mid-position valve. No rads get hot (or even warm) before boiler shuts down.
The pump starts running as soon as I apply mains & before boiler is started - this has only been happening...
Boiler pipes get hot when boiler is on - as already stated when I force the mid-position valve to the right (towards the lock position) all pipes immediately get colder and after a short time the boiler shuts down with a load click. The piot goes out at the same time as the main burner so the...
Any help/advice would be appreciated ref this problem.
My boiler cuts out after a few minutes running - obviously overheating. The main burner & the pilot go out & I have to wait about 5 mins before I can re-light it.
I think that there is a problem with the mid-position valve as it is...
My old Apollo was working fine up until a few days ago when it went out & the pilot refused to stay lit when I released the valve.
I replaced the thermocouple & the pilot head with no improvement. I eventually managed to get the pilot to stay lit when I short circuited (for testing) the...