Recent content by simonbridge

Dear all, The AEG OKO Favorit 54750VI Dishwasher, model ref: 911796023 is displaying the following: Start of any cycle it pumps out any stale water (this is normal) then goes to the call for water cycle, at this stage it is not getting any water and so cuts out with an error code that...

Just guessing here, but as lipstick contains a lot of fats, try a simple stong solution of fairy/water! Could try vinegar but that'd stink like a chippy. Kids eh! who'd have em?

Thanks all.

Thanks Artful, just the right sort of advice. I have now changed the pump, drained, refilled and bled the system. This is where it gets weird.. i contacted Hepworths who said that the only possible solution was that the 3 way valve was faulty as this is a fully pumped system. However...

I have a Hepworth Fuelsaver 45, I posted that I was getting banging from the system on morning startup and have thus acquired a new pump, some sludge remover and some inhibitor for when all is clean, however..... I put the sludge cleaner in the F&E tank, turned on the CH to circulate and yet the...

OK, Thanks so far The pump runs continuously when timer on 24hrs, it runs to time when on any other program. The pump is an Euramo Gold (Wilo????). so I have been looking at changing it for a Wilo Goldstar 15/60. Do you think this is a good choice. The pump height is 130mm and the thread...

http://www.cwgsy.net/community/tosy/website.htm http://www.onestopenglish.com/News/Magazine/Archive/esl_teach_createwebpages.htm But there are loads of others. If you have decided on a host then try the above. If you have not decided on a host (and want to pay... ie its a commercial site...

Just a couple of additional points! Definitely buy a router/modem with an SPI firewall built in, then NAT addresses internally to a statically assigned IP address (check your ISP can give you this otherwise you'll be mucking about with dyndns), this will mean that you can remotely administer...

Hello, I am a bit confused (took all of 10 seconds!). I have been reading through the last 12 months posts on banging boilers and am now confused. I have a Hepworth Fuelsaver 45, situated in the basement of a 3 story house (i.e 4 floors incl. basement), The pump is situated on the ground...