I used to have an immersion years ago and my heater element burned out - measure resistance (remove cap) (power to heater off first) - SHould be about 18-20 odd if OK (for a 3KW heater)
Thanks for replying
I have watched it and the flame goes out - would that mean it could be a lot of things at fault though?
What is cross leaking? I am wary about turning valves off under boilers as I have heard they leak and cause problems after!
Hi, my first post on this forum so here goes-
My combi boiler hot water goes hot then after a while runs cold - then about a minute or more later starts getting hot again - this cycle happens in a cycle
I have been searching the site and found it it could be the secondary heat exchanger...