The little white tube you describe is the water feed going into the condensor for the dry cycle. The water should be contained in the outer black section.
The only sure way to clean a blocked Bosch dispenser is to remove it from the machine and split the top off the unit. This lets you get right inside to clean it properly
As you say it is very common on Bosch. Eric.
HI.
Firstly has the machine worked since you moved?
Does the machine empty the water out ok?
If the soap is gone from the drawer then it must have been taken into the machine when it filled.
If the answer to the above is yes. Turn the dial to a black dot and it will reset the timer. The red...
Hi.
After unplugging the driver, remove the lid and the left side panel (looking from the back) You will see the motor near the back. The capacitor can be either a silver cannister with two connections on top or a grey plastic tube with connections on top. Usually marked as 7uf .
Chances are...
The pressure switch has a small rubber or plastic hose connected to it. Check that it does not have any holes rubbed in it along its length. Pull the hose off the pressure switch and blow into the switch, it will click probably twice the harder you blow into it. When the pressure is released it...
Hi.
10 flashes indicates a fault in the pressure switch area. Check for loose conections on the pressure switch and module. Check for operation of the switch by removing the clear tube on the switch and blowing gently into the switch, you will hear it click once. When the pressure is released...
Hi.
10 flashes indicates a fault in the pressure switch area. Check for loose conections on the pressure switch and module. Check for operation of the switch by removing the clear tube on the switch and blowing gently into the switch, you will hear it click once. When the pressure is released...
Hi there.
Sounds like the machine has gone into flood mode. There will be water in the base which turns on the pump and overides any other controls. Try tipping the dishwasher backwards and see what runs out on the floor.
If you have water in the base then you need to check for leaks.
Hi.
Seven flashes means there is no water getting to the dishwasher. Did you turn the water off when you emptied it? To clear the flash code, hold the start button in for more than 5 seconds.
Hi.
Fixed one of these (HNC160) with the same fault only yesterday. Replaced the board as a unit and the relay now holds in. Hoover part number for the one I used was 91201247.
Hi There.
The filter care light staying on means that the thermal cut out on the element has gone. They cannot be replaced as a seperate part.(no suprise there then.) You need to buy a new heater unit complete with cut outs.
Eric.
Hi Jon.
Flood protection on a Bosch would result in the drain pump running .On some models it still runs even when the door is opened. Sounds more like a pcb fault or power loss to the machine. The plug in the wall socket is ok isn't it?
Cheers Eric.