Recent content by Sparkyrbh

O.k Thanks Europlex. Do you have any other helpful suggestions?

O.k to be clear I have checked the fuses out of the holders and on the board. the fuses test out O.K. they are not blown. I checked for voltages on the board with them in also. i.e checked voltage either side back to -ve, NOT black on one and red on the other. I followed the exact...

O.K guys, I disconnected mains and battery, shorted out the NVM reset, as per the instruction guide, reapplied mains and waited. As there is no power to the keypad when the battery is disconnected, I cannot tell/know when the re-boot is complete. With the NVM pins shorted, Mains connected...

O.K , Thanks both, I'll give it a go. Full power down and reset. Fingers crossed!

Thanks Alarm. Not sure if you wanted me to disconnect all the sensor circuits Here's the score:- Without the battery connected. I have 240 v on primary side of TX, I have 19.4 v on the secondary. I have 19.4 V either side of the 2a AC Mains fuse on the board. All looks well. however...

A few months a go I started a query about Pyronix Burglar Alarms. Basically I was doing some work, disconnected the mains, but left the battery connected. It drained down ( quite quickly actually) and the beep indicating power supply loss went quiet. Forgetting that with such cheap crap, the...

I am obviously not an expert, but I would guess that it is a problem with the battery in your control Box and I would change it for the relatively low cost and particularly if it has been installed for over 5 years, its easy done. I would summise that the reason the outside alarm goes off is...

Thanks for response. I had a feeling it may be the battery. although initially I had disconnected the battery and with the mains on, the problem still persisted...dead! Anyway for everyones reference, I changed the battery and the system has immediately come to life, settings appear to have...

Hello. I have a Pyronix Sterling 10 installed which was working fine until I switched the mains power off to reposition the fused spur feeding it. The power has been off several times for various DIY needs as the house is in need of general upgrade and I've never had a problem before. The...