aah
i asked for 15-22.
but also explained exactly what i wanted it for!!!
also, i have six legs fixed to the bottom of the bath, two on the panel edge corners and two wall fixings.
do i need to fix the legs to the floor or are they ok as they are?
thanx
been to my local plumb centre today to get the 15-22 braided flexi and was assured such a thing does not exist!?
my only option as am not happy with my ability to solder is from original copper, extend to plastic to original copper to tap!
a bit of a mix n match but is this acceptable...
oh by the way, i live in a very hard water area and have heard a water softener would be a good asset.
i have no idea.
could some one advise on cost, wher to purchase, and further materials needed.
and more importantly would some one with basic plumbing knowledge be able to install one...
thanks
sorry to trouble you yet again!
i have a screed floor with the copper running along the eges in a dug out section boarded over the top.
will this affect btu.
is a first floor maiseonnete
as is easily accsesable is it acceptable to couple from copper to plastic to chrome plated...
thanx
hi the room is 2 metre square by 2.3 cieling hight with one exterior wall containing a window, reveal opening is 1 metre high by 1.2 wide.
any ideas on the seeming lack of valves? and what i need to add to the install of the towel rad?
regards
Hi thanx for the speedy reply.
i have looked at a couple of towel rads in wicksy, they were similer in size but had totally different btu.
is this just for the towel rad or does it effect the boiler and what it can put out?
the rad i hope to replace is only 2 ft high by 19 inch wide and...
Hi plumbers. I am replacing my bath suit at the mo. I bought 2 pairs of 15mm braided flexi connecters with ball valves, but forgot the tap thread on the bath is larger.
i cant find a replacement 15mm - 22mm?
am running plasic from the original copper.
no one in homebase/b=q is of any use...