Recent content by synthasandwich

Hi again, The machine won't settle on the drain mode, dial just keeps missing it. We're currently relying on gravity to empty the water.... wires are connected. Wife just got home and thinks it's time to give over tinkering, machine is pretty old and looks like we're getting a new...

Hi Rocks1 yeh, I just pulled out the filter and it was completely empty. Took off the waste pipe and blew down it with a clean mouth piece- blew straight through and clearish water out. Does this leave the pump? Or is there anything else? cheers Mark

Hi All, I've done a bit of digging and have found that the fault code is drain fault. I just wondered if it is simply the pump or whether it is the PCB board - just hoping there is a sequence of checks. It stops when it should drain and flashes 11 times with the dial clicking around, we...

Hi again Rocks1 No worries, it was my fault jumping to conclusions. The board looked on it's way out anyway, it was scorched on a number of sections. The brushes are off and they are worn down so I have just ordered some more of those. It's all good- I'm learning, have never delved into...

Oh man, This board hasn't made any difference.... The machine on reset flashes rapidly and then continues to flash normally with no error codes. When you put it to a program, it flashes rapidly and then locks the door but does nothing. What could it be? Mark.

Hi again, that's a great relief ( as I can't afford a new washer yet. ) Will plug it in and give it a whirl :lol: ........ the PCB board has arrived today. Thank you again, much appreciated Mark.

Hi Rocks1, I have no megger, just a bog standard voltage tester. I've had a look at the plugs on the interlock and on the timer and they seem fine but most of the burning seems to be around the white 4 pin plug in this picture- ( power plug? ) Any ideas? It has the right EMPROM...

Hi everyone, Firstly, thanks for reading my post. I have a 7 year old Indesit washing machine model w123s where the control PCB at the back has a number of burned out sections on the board but none of the terminals are burnt out. I have gotten a cheap PCB board from a tradesman who...