would this design below work?
The red circle bottom right represents my CH pump. Blue box is cold cistern. Make sense?
My thermostat goes to the cylinder on the left, Presumably the cylinder on the right won't need a thermostat then?
Ok, so i'll parallel all the pipework and provide seperate feed at same height from the cisterm above and extend the flow/return pipework too.
What happens about the thermostat? Is it acceptable to just have the one thermostat on the original cylinder and assume they'll both heat properly?
I have a 900mmx450mm size cylinder about 114 litres and I have plenty room for another next to it. Is it possible to join them together? I need more hot water capacity due to a large bath, two mixer showers etc.
I have an extractor fan in my kitchen almost ready to use, problem is that the hole size on the vent is 150mm wide. and the hole through the wall is square and is 100mm wide.
I'm trying to find one of these
but not having much look. I can't use reducers because the ceiling is lower...