Recent content by Tempus009

  1. T

    No CH on Biasi M110.32SM/E Garda Plus HE Boiler

    Tony, I have the kit to do this but will have to try this evening as we are away out soon. I printed out the service manual so should be able to find the right bits etc. I'll keep in touch. Thanks, Tempus
  2. T

    No CH on Biasi M110.32SM/E Garda Plus HE Boiler

    Tony, Got the pin down on the valve and we had heating this morning. I had to go out and the time clock turned the heating off whilst I was out. The heating was turned on again (the connector was still not attached) but this time the heating did not circulate the system. So I attached the...
  3. T

    No CH on Biasi M110.32SM/E Garda Plus HE Boiler

    Tony, I had a look at the Diverter valve and the connections. On my boiler the connector is a solid one iece with the spade terminals built into it. There is a solid piece of plastic on the connector to stop anyone fitting it incorrectly and so I don't really want to break the connector apart...
  4. T

    No CH on Biasi M110.32SM/E Garda Plus HE Boiler

    Tony, Off for lunch now and won't be back for the day. Thanks for your assistance and I'll try this out as soon as I can. Merry Christmas.
  5. T

    No CH on Biasi M110.32SM/E Garda Plus HE Boiler

    Merry Christmas anyone who is reading these posts! Tony, The boiler doesn't feel particularly hot at either the top or the bottom, just warm as you would expect with the boiler on. When the CH is on and the CH temp is set at 4 the water temp gets up to 60C and stays there and the supply pipe...
  6. T

    No CH on Biasi M110.32SM/E Garda Plus HE Boiler

    Probably right. DHW is set at 6 and CH is set at about 4 depending upon outside temp. If it's really cold I turn it up to 5. I have tried CH at all positions from 1 to 7 and if I set it at 7 the Temp gauge goes up to about 85C with the boiler cycling.
  7. T

    No CH on Biasi M110.32SM/E Garda Plus HE Boiler

    Tony, Thanks for responding. The 1st and 3rd light flash together approx 2/3 seconds between flashes. There is no room stat and so the boiler should be providing heat to the CH system. Sorry, but I don't know what you mean with the CH isolating valves. Clock display says "ON" but it is...
  8. T

    No CH on Biasi M110.32SM/E Garda Plus HE Boiler

    Hi, I have a Biasi M110.32SM/E Condensing HE Boiler which produces loads of hot water but the CH starts up for a short time and then cycles and no heat is distributed around the system. I have had an engineer around and it worked OK when he came but since then the CH has died. When it comes on...
Back
Top