Recent content by theheatinghelper

been on the site for a month quoted 4 boiler changes @ £20 + vat every lead not one boiler change over £1350.......... one had pro 28 magna clean honeywell wireless stat a powerflush and integral timer blaaaaaaaaaaaaaaaaa rubbish site ,,,,blowssssssssssssss

I'll be honest , I only had a neon at hand and there was no power at the fan it's self

it is mate

heating and h/w tries to kick in but 60 light stays on , indicates pump but the pump is spinning but ...the fan dont kick in pressure switch seems to be working fine ...... im undecided on a new pcb or a new fan any ideas all ?? thanks

ok mr agile how about.... customer needs hot water to fill a bath and a basin, dont want a cylinderas needs cupboard space as its only a small flat, mains water no where near the cupboard, cold feed off down service and cupboard in the center of the flat nowhere near an outside wall

just a guess ? pcb ?

just found this //www.diynot.com/forums/viewtopic.php?t=205257 also f22 is over heat , is pump actually spinning ? or over heat stat faulty ? you can view each of the flexi com model manuals online and search for the diagnostic and fault codes

ok bit worried as i fitted three of them today and i run the hot water for about a minute and it started to go cold again ?!?!?!??!! oh **** !

ummmmm is it me or does the said boiler have not diverter valve ? its not a combi its a heat source only boiler , the silver box is the same as the pictures above and are situated somewhere on your heating system , normally in your cylinder cupboard, there is a manual lever that can be pushed...

try a 3port valve the silver small box in your cylinder cupboard, or the pcb on these boilers go aswell !!

re: gas pipe .....might be an idea for a gas safe engineer to look at the job for you

3 men y plan , one day rip everything out all new back in 3 men combi system finished by 3pm all out all in 1 man 2 & half days y plan (same ) 1 man 2 days combi system (same )

the option id go for would be the cylinder, header tank and a pump, but it seems you wont have enough room for a header tank big enough to serve the pump , have a look at this its just another idea http://www.elsonhotwater.co.uk/html/thermal-stores.htm ive fitted electric combis and some...

great just read a few reviews they seem exactly whats needed, i would probably fit two-15ltr and one 10ltr, is the recovery time the only diffrence with 2 - 3 kw ?

i need some advice, ive been asked by a night club owner to replace 3 electric water heaters. They are all "zip aqua point II " one feeds two hot taps the second and third are piped together and feed 8 hot taps in gents and ladies toilets ive only got an incoming of 8 litres the club...