Thanks Alex and you are probably quite right in what you say but I have already put down a 6" hard core base, with agregate, sharp sand and flags on it so it need to sit on that. Certainly don't want to redo it and there is really no need anyway. I would have gone down your route for a workshop...
Links to Biohort sellers:
Cheapest:
http://www.taylorsgardenbuildings.co.uk/store/customer/product.php?productid=17065
Another:
http://www.shedstore.co.uk/itemdetl.php/clashist/Metal_Sheds/Biohort/Europa/findclas/Europa/itemprcd/bio88eur
Timber - Link to a site with 19mm tanalised...
Didn,t really want to open the debate of wooden vs Metal vs plastic as we all have favourites.
I have to date had only bad experiences with wooden ones, but I have to admit I have never gone out and spent £1k + on one.
The best one I ever built was a pre-fabricated concrete one on a sound...
Some are that I have looked at, but some are much better made than any commercially built same price wooden ones, and will outlast them by far.
Wooden sheds as a storage shed:
Easy to set fire to ( had it done )
Easy to break into ( neighbours had it done earlier this yr )
High...
Just finished laying a paved area which is 10'Wide x 8'6" Deep.
Paving has been layed on a damproof membrane to help reduce condensation.
I am looking ideally for an 8' x 8' metal shed to relieve some valuable space in my garage/workshop. Going to poly the roof to help reduce dripping...
Thanks guys for your help again.
This has clarified another grey area for me.
Although I have only asked to have a couple of issues explained on this forum, I have gained a tremendous amount of understanding by reading many posts and spending much time searching for various topics.
I...
Further to my last post on trying to understand my system a little better, I have a question about which is the positive and which is the negative side of my system?
My System: 19 yr old Open vented fully pumped with mid position diverter valve.
Boiler: Potterton Flamingo
3 port valve
3...
Thanks for your reply.
Yes, my service engineer said that about my type of system.
The valves are not actually in the cistern feed or the vent pipe. They are in the main run from the boiler thru' to the pump. One positioned either side of where the feed enters it. Similar to the valves...
First post, so be gentle please.
System: 19 yr old Open vented fully pumped with mid position diverter valve.
Boiler: Potterton Flamingo
3 port valve
3 speed pump
6 radiators
Installation is in a bungallow with most pipework dropping from the attic.
Boiler location: Garage
Each time...