Recent content by trotters

If there is no inspection panel on the outside of the case then......DO NOT be tempted to remove the casing!!!! Even when disconnected from mains supply you can still get enough volts up your arm to kill you if you touch the wrong wire.

Check the door is closing properly.......I know it sounds sillY !!! But you have proved there is power to the machine and it wont do anything if it thinks the door is not closed. Is there a humming noise? try selecting drain/spin & listen for a himming noise. Is the machine connected to a...

The best way is to extend the drainage pipe TO the appliance rather than trying to extend the drain hose FROM the appliance. Using this method, the drain pump of the appliance won't be over worked, also if you are extending the supply pipework it is a good idea to make sure you can access the...

The door may be jammed because the machine has not drained all the water out? Try a spin/drain cycle & then wait a couple of minutes. If it hasn't drained then the easiest way to drain it manualy is to put the drain hose (Grey flexible) into a bowl on the floor and let the water syphon out...

If you open the filter door on the front of the machine you should find the number you need, if not then check either the door rim or around the front of machine where the door closes you should find a label with the numbers on. :shock:

I am looking to fit a new towel rad. There are so many available ....I have been advised that they are generally not the best quality compared to standard rads. Do I need to buy a stainless steel or will a chrome plated be okay? I need an output of around 2200 btu\\\'s from a 400 to 450mm wide...