I need to paint my soffits and fascia. The paint has chipped and is pealing in places. It's a long overdue project.
Bedec barn paint has been recommended but is very pricey - would people agree that this is the best paint to use?
I need to add pressure to my vokera boiler - Linea 28
it is used with gas and is a combi boiler
I have done this before but i forget. I know how and where to pump air into it but should i drain it first and then turn valve to add water??
i bleed a radiator tonight and the only thing that...
plug has been removed and screw length adjusted - no joy.
some one has mentioned about the conection underneath the bath and a wire? what would i need to do?
I have a new bath and were the overflow is there is a device that you turn and it makes the plug move up or down. This was pushed down by accident.
Any idea on how i fix this?
The ceiling pendant on my upstairs landing was broken and not holding the blub in so I bought a new one a wired it exactly how it was wired before. I switched the electricity back on but it didn't light the blub.
On my fuse board there is a fuse for upstairs and downstairs lights. The...
Water only leaked out of the copper pipe in the boiler when the bung was on the outside pipe. The pressure was at 3 bar but the water ONLY started to leak once I have turned the heating off. since then, I put a clear plastic bag on outside pipe to see if water is constantly being blown off...
if i leave valve open it lets the air pressure that i pump in out.
also does anyone have any ideas why the water pressure keeps dropping if theres no leaks anywere and water is not being blown off by safety valve?
I bleed the boiler and then pumped 1.5 bar air pressure into valve as suggested. however this pressure also showed on my boiler gauge but to my mind it should only show water pressure not air pressure. So I put water in the boiler until it read 2 bar. but after the heating was on 5 mins the...
FINALLY, got someone out to check for leaks. None found. he put a bung on the outside copper pipe. he told me to keep an eye on the pressure. (he had left the boiler at 1.5 pressure) within 30 mins pressure was up to 3 bar (he told me if this happend to turn heating off), I turned the boiler...
The problem has been a continous one. I would repressurise the boiler to about 2.5.
Were, what how much is a pressure vessel?
also, when the heating comes on my radiators would make a whistling noise but his stops if i move the valve. could this be related?