Recent content by Vinny1

Hi all, I know its a hot subject but I have used it in my sons house several years ago. I am using it again and wonder where are the technical documentation for the installation? Or how to For instance When installing up to the radiator, is it okay to run the 22mm pushfit pipe 45 degrees or...

Thanks everyone for your help and advice. I have disconnected the COMip module and back to the panel. Only issue now is that I do not think I have set it up correctly as I get a area in exit a with the sounder going... I wonder if i have set up the zones, groups areas? I wanted to have area a...

So would you suggest that i change to the other board and app? It seems the other board is not so hard to configure with port forwarding. I guess they have made it easier to configure? I am still stuck on mine.

Thanks DiWhat, I found this from Texecom that mentions it will work with the hardware. https://www.texe.com/Apps/INS580_AndroidAppEngineersGuide.pdf

I managed to make a move forward I hope. I found the IP address on my router and reserved the IP add to keep. On my router I can only set approved settings and used the BT alarm to allow port forwarding. I then try to enable the COMip on the board but get Incorrect config Call terminated. I...

Thanks for your reply. I am sorry if i did not make it clear or missed information. Its a texecom premier elite 48 ver sw v4.02.01LS1 I added a premier elite Com ip board to add the app to my phone. I have only just commissioned the system and am still getting used to the software. so far i...

I had one of my PIR not working then when i checked I had changed the wires on this one thinking it was the same as the others. I hope you get it sorted.

I had some issues on mine to connect. from the T i would say this is tamper and it has to be looped back. Then its normally a strobe, bell and power. from your notes it seems you have two types of strobe? plus and minus i guess for different versions. Could you test the bell by using the panel...

Hi hope you can help me. I have set up a texecom premier elite panel and am trying to configure the Comip module to work with my phone. Currently when i try to enable the texecom connect app i get the error code incorrect config call terminated I also was getting arc fault on the panel I...