floating beads or thin coat angle beads - what is the difference??
all i know is the plasterer used a 90 degree metal piece to make the straight edge. does this help?
hi
i have had 2 rooms plastered by 2 seperate plaster's (timing reasons) and i have now tried painting these 2 rooms - 1 problem. i am seeing these marks (see photo's) around the window on both plastered rooms when i try painting the plaster. does anyone have any ideas what this is and how to...
hi
i have had 2 rooms plastered by 2 seperate plaster's (timing reasons) and i have now tried painting these 2 rooms - 1 problem. i am seeing these marks (see photo's) around the window on both plastered rooms when i try painting the plaster. does anyone have any ideas what this is and how to...
so how do i get rid of the marks?
i have painted im guessing the walls will be sealed so will i need to sand back the paint and wait for it to dry out, or do i need to put something else on the walls to cure the salts showing?
sorry im a bit of an amature at this!
Hi All
i have recently had my kitchen re-plastered, i waited until the plaster dried then painted on some 1 coat matt paint, all good so far...
i put on 2 coats - just to make sure i covered it all as im not the most experienced painter! then about a week after it dried i started to...
Hi All
i have recently had my kitchen re-plastered, i waited until the plaster dried then painted on some 1 coat matt paint, all good so far...
i put on 2 coats - just to make sure i covered it all as im not the most experienced painter! then about a week after it dried i started to see...
hi all
fairly new to this so probably asking some silly questions but anyway!
basically i need to know if where my electricity supply comes into my house, can i run a pipe (plastic or copper)behind recessed into the skirtiing board or boxed out and insulated/earthed for a radiator further...
for me to do that i would have to go behind my electricty supply coming into the house (below the consumer unit - iv tried to upload a foto and added a link too?)
//www.diynot.com/network/watson789/albums/4333/17337
is it legal to do this?
what are the rules on pipes and...