XanderHarris's latest activity

Thanks may not then. They recommend to use full bore isos on gravity feed systemd

Yes. I no I'm going to get restriction in the tap body. Put if I can get better flow till that point. It should help?

Can you swap the flexis that come with monoblock kitchen taps for the copper tap tails? I want to try get better flow. Thanks

Can the pressure relief from these 15 litre unvented cylinders go into a waste branch that has over appliances on it?

Would a Flexi installed like this before ok. Would be for a concealed cistern. Or would that be classed as going up hill?

What could I use as a spacer?

Thanks I was looking at these are this just a Flexi but with speedfit pipe?

Can you adjust the nuts that secure the float valve to the cistern ,in order to take the float valve further into the cistern ,creating...

It's a solid nut on the other side sadly

I have this concealed cistern 500mm it's tight too tight for a soldered bent tap connector are end feed ones tighter? Or any other...

It's all it can be if leaking. Check that it's secured tightly first, although if it wasn't you'd probably feel it was loose when...

I have this tap leaking slowing constantly from the tap body. Does it need a new cartridge? I'm guessing it's the oring on the cartridge...

Interesting

Is it kind of a hard one to tell without seeing it? Thanks for any advice

It should be ok or calls for skimming