Recent content by zofo

Dave Instructions aren't that specific and just refer to possible requirement to shield (run is only abouit 18m at most and not all alongside mains cable) Instructions gives avery generic "standard", cable type, code . attched is link to instructions...

I suppose my question is do they work and how. More specifically iam interested in the merits, or otherwise, of the system I mention i.e. ease of set up and use. Have looked at worcester Td200 contrioller instructions and it does look a tad complex to set up.

Yes it does run on low voltage 10-15v Dc according to blurb. What sort of shielded cable would you recommend as the cable has to run alongside the boilers mains supply cable.

Just canvassing opinion from those in the know out there regarding the merits or otherwise of optimising systmes for domestic boilers. Have read blurb regarding Worcester Bosch TD200 and associated RT10 stat and thinking of installing in with new worcester Combi. Views from anyone with...

gas for you Thanks for reply. I guess I might try with existing cable and then just upgrade if necessary to a better spec of cable. Although Iam suprised at the poor qulity of the worcester installation instructions.

Thanks for reply. I can see benefits, particulary to the electrics averse out there, with the RF types. However, I prefer to have a hard wired thermostat ie no battery replacment, or other potential signal problems that I believe can be experienced with RF types

Have decided to have a Worcester Bosch (WB) TD200 controller and an WB RT10 thermostat installed on on a WB 42CDi combi. Work is being done by a COrgi engineer. However Iam going to run the cable from stat to controller(if needed). However Iam unsure having looked at the instructions for...