Search results

Hi there, I have a new hot water cylinder fitted by a builder, after works completed everything worked perfectly for three months, then I completely loss the hot water, nothing is coming out off the taps.The fuse and power are find, the water is heated normally but impossible to get any hot...

Hi there! From my last posting regarding,...63Apms connectors... At the power source I have a MCB and at the other end I should have some RCD's, question: I don’t have any 20Amps & 10Amps RCD but only MBN from Hager for the shed CU will this do the job or I have to invest in RCD? :?: On...

Hi there! I need some advice; I am going to install a "sub" distribution box in an extension shed built in my garden. I have a 3 cores 6mm2 from the 63Amp fuse of the house's existing DB, this going to the extension shed; but my 3 cores 6mm2 is too short at about 3m to that extension shed...

I had to fit a timer on the immertion heater. I went in the distribution box, I put down the breaker in question MCB/B20 I checked for any power with my tester at the end of the wires in the HP, no power so I thought that I was safe, what happened was by two times when I was working with the...

I just fitted a Monsoon Positve 4.0 bars twin pump. The pump starts when outlets are on but doesn't stop. I checked for leaks no leaks. I checked with a magnet if the reed clamps stars yes it does.I checked the wiring (for closed circuit) of the flow switch reed, it seems ok as per diagrams. So...

I need to fit a shower pump in my house, the pum needs a 30ma RCD, power via a double switched fuse with a 13Amps. I have a 13A isolator switch which will be in the hot press next to the pump and a cable from this switch going to the distribution board where I already have a 30ma RCD 40Amps. My...