Search results

Here is a photo of before I added the washer, this shows where the water is escaping. I will try with more silicone and upload a photo of the inside where it is glued.

Hi. I've recently had a l shaped bath and shower screen installed. All is ok except for a slight leak on the bottom seal on the corner piece. The screen has a small glass return on the "L" of the bath. At the bottom the straight edges have plastic seals, on the corner there is a separate...

The flush rate is at maximum already, the cistern almost empties when I flush. As I mentioned previously, if I block the overflow and add more water I get a good flush. As the cistern only holds 6 litres when full, being 2 litres short is giving an inadequate flush. I'd rather not replace...

Ok, my syphon is similar to this - http://www.screwfix.com/p/fluidmaster-push-button-cable-dual-flush-valve/51173 but it hasn't got the height adjustment on the overflow pipe. If I fill the cistern just short of the overflow level I am about 2 litres short of water! I need to lift the...

It is a syphon flush and it came with the cistern so I don't understand why it is too short in the first place, perhaps whoever fitted it cut it shorter! Would my idea of gluing an extension to it not work, I'd rather do that then replace the whole syphon.

I have a concealed cistern with an internal overflow. The problem I have is the height of the overflow pipe is too low, the water level is a couple of litres lower than the maximum and the flush is poor. As a test I blocked the overflow and lifted the water level to the maximum, the flush is...

I have a scalemaster "magnetic speedfit scale inhibitor" fited to the cold water feed of my combi boiler. The problem is that the push-fit fitting on the bottom (input) of it is leaking. How do I go about stopping the leak?

Hi, When I had my old wooden front door replaced for a UPVC door I specified a pad handle to replicate the functionality of the Yale lock I had. It works great apart from the fact that there is no way to put the lock "on the latch" like you can with a nightlatch. I'd like the ability to...

Hi, I have recently replaced my front door with a upvc door from www.u-fit.com. The door is great and much better than the old wooden one I had but I have a couple of problems with it. Firstly, I found that the opening side of the door was dragging slightly on the floor but after...