Search results

hello My car is a saab 93 2.2tdi 2002 I have started losing acceleration power and the engine light has come on. it wasnt long after i had put some diesel in. i have nearly used up that diesel so i have now put in half a tank thinking it might be a bad batch, if there is such a thing. since...

Didn't open bleed nipple to let fluid out, but brake pedal does feel spongy. How do I bleed them? Thanks

Hello Am changing the front pads on a mondeo 18.00ltr year 2000. Have taken the old ones off and put the new ones on. How do I bleed them? Thanks!!! Ian :?:

Hi Thanks for your help. Have taken old ones off and put new ones on. How do you bleed them? Regards Ian

im trying to change my front pads on a mondeo 18.00ltr year 2000. as i havent got a manual im struggling ive got as far as taking the spring clip off. anyone know the next step ?

ah so easy! many thanks.

its about combi boilers in general. this is wot i think i know. with a combi boiler you dont have a cwsc or hwc, so im guessing the cold taps are mains fed and teed off to combi for hot water. if this is right where do i get my feeds for hot and cold if i want to plumb in a manual mixer shower...

this is a bit long winded but bear with me. I was planning to plumb a manual mixer shower in by running pipe from hwc to the hot and teeing off the cold bath tap, but after looking in airing cupboard there was absolutely no room to do anything, so i thought there seems like enough pressure at...

mains pressure

If i have good pressure from the hot and cold bath taps is there any reason why i can't draw off those taps to pipe into mixer shower.

thanks . think i'll get a pump, if im gonna have one i might as well have a good'n. cheers for info.

oh ok, lets go on the assumption that cold water is indirect and cwsc is 1 mtr above shower head

thanks for advice. just one more thing. the pipe run for the hot water will be roughly 4 mtrs, would that normally be a pump job or is that ok for gravity fed bearing in mind it is just normal size hwc.

i want to tee off the hot water cylinder for shower, how far up the pipe will the hot water reach. basically what im trying to say is if i tee off just into the loft and then pipe across to the shower will it gravity feed up the pipe enough to get pressure.

2 things really. first is how do i know if i have enough pressure to install shower, and secondly when i tee off the hot water cylinder is it best to go up into loft and across or down under floor boards and across. Also shower will be fitted to external wall, if i chisel out runs for pipework...

thanks give it a try.

have a problem with a sink tap that turns itself on. it is a lever tap . any suggestions would be gratefully recieved.

sry, what is the difference between stack and vent pipe, no there is no toilet connected to this pipe, just the bathroom sink and bath

i am fitting a toilet in an room that only has a sink and bath. the soil stack is piped outside on the side where the bath is. do i need to fit a separate stack for the toilet or can i just pipe the toilet waste into the waste drain round the corner which is about 15ft away. thankyou

chemical flushed under pressure in heating system. Since then some upstairs radiators need bleeding every three days. This problem has been continous since november 2008. The only fitting done was a gate valve on f&e tank