Search results

changing toilet and the waste pipe has an elbow coming up thru the floor boards.... its not 4inch... put multiwik and its very loose... cant change the waste.... is there anyway to make a secure joint.... could use silicone but is there a better way

:D cheers

The waste is under the floor (plastic)... easy enought to get to it.... moving the waste back about 150mm to fit a close coupled toilet... in cutting the floorboards to fit new waste pipe through wats the best way for support the waste so it doesnt move

have an sds drill...6mm bit... would it be best to get a diamond drill bit.. do i use drill first and then hammer after you get a grove goin in it

The 4inch waste is about 200mm off the wall... I wonder if i use a swan neck multiwic could i fit a close coupled toilet.. plan to remove low level one... can put up picture tomoro if needed

yea pumped shower mate

Only one tank in the attic... cylinder directly below it... top of the cylinder is hot water pipe feeding all the hots.. for installing a shower would i have to use a surry flange or would there be a handier way

Legend :wink:

[email protected] cheers kev :D

is it anywhere online or anything... save you the hassel mate

Would it be possible to get a manual for this???

Lovely jubbly cheers seco

When putting taps in, how much copper is needed before ya run it into qualpex???

cheers, it was the bylaw 30 kit i was looking for , didnt know the name

Is there a kit ya can buy with all the stuff ya need to install a coffin tank

Is there anywhere on the web that ya could get all measurements for different sinks,urinals etc

No theres two tanks in the attic....