Search results

  1. A

    Disputing a Planning Enforcement Officers Decision

    My neighbour in 2004 had planning permission to extend their single story flat roof extension on the rear of their house. Various conditions were stipulated by the council. The two relevent ones to my question are 1) the extension could not extend past the end of my house and 2) No access to...
  2. A

    NHBC House and Damp - But house not built to NHBC standards

    Situation is that my parents house built 22 years ago was NHBC guaranteed. They are not the original owners and purchased after the house was 12 years old. Now it has serious damp. The damp expert has had a look and he has said that the damp is coming up through the concrete floor because...
  3. A

    What does a boiler do when the CH water is up to Temp

    So I have a WB 400, I have no thermostat on the system, trvs on rads and a timer. I have read the manual and it says that when the water returning to the boiler is up to temp then the burner switches off, the pump will run for a short time to dissipate heat then turn off. I can see how...
  4. A

    SMEG Oven Fan Oven not working Normal mode works fine

    I have a SMEG fan oven. When I select either fan oven or fan grill it does not heat up. When I select a normal oven and normal grill it works fine. Does anybody know what part to change as seeing as it works normally then this does not suggest that the heating element has gone. TIA.
  5. A

    Adding a Zone to exisiting CH system

    Current system is combi boiler and for the central heating I have a 22mm core central heating ring (if this is the correct term). The rads are dropped of from the flow pipe and then returned to the return pipe. The boiler is in the coal shed the flow and return pipes enter the house are fed...
  6. A

    Worcestor Bosch highflow 400 electronic RSF - Potential Prob

    I hope this is the forum to ask, I have a Worcester Bosch Highflow electronic 400 combi boiler, the installer did a mains pressure test and flow rate test before installation and said all was fine. It is meant to have a flow rate of hot water of 18 litres a minute. Because of a thread on another...
Back
Top