Search results

  1. C

    Header tank

    Should the central heating header tank be hot, when my central heating is on?
  2. C

    Capping gas fire

    If your gas safe registered for a firm. Could you cap a gas fire off as a private job for yourself. Or do you need your own gas safe registration?
  3. C

    Plumbing lecturer

    Has anyone worked as a plumbing lecturer and can share abit about what it's like please? Thanks
  4. C

    Dew point of natural gas

    Can anyone explain what the dew point of natural gas means?
  5. C

    Concealed toilet

    Are this plastic elbow that come with this fluidmaster concealed cistern any good? I taken it I can then pipe it with a flexi as it's a 1/2 flat face.
  6. C

    What liners for this plastic

    I am struggling to identify the make of this plastic so I know what liners to use. I'm going to compression so I don't think it's too vital as long as tight. Thanks
  7. C

    Nail in clips

    Is there anyway of stopping the nails on these from stopping rusting?
  8. C

    Outside tap internal DCV

    Is it water regs that a new outside tap installation needs an internal DCV? No one built in to the tap?
  9. C

    SBR bond and tubed addy

    Can tubed adeshive be used if you have primed with SBR bond? Does tubed addy relie on mositure being absorbed by the substrate?
  10. C

    Rad. Valve leak

    What will the seal be on this as the microbore pipe connects to the rad. Valve. A rubber washer?
  11. C

    Polyplumb fittings hand tight or more

    Is hand tight enough for the nut on a polypipe fitting or is a tweak with a pair of grips warranted?
  12. C

    Encasing pushfit fittings

    I'm correct in saying you can't sold encase pushfit fittings as they need to expand for the gran ring to bite in?
  13. C

    Polypipe/polymax

    Are polymax fittings ok on polypipe? Are the liners the same?
  14. C

    Polypipe fitting failed after 1.5/2years

    Hi does anyone know why a polypipe fitting may fail on a central heating system 1.5/2 years since install?
  15. C

    Changing pop up waste bar

    I have a tap to change on this so will have a new pop up waste bar. Is it possible just to just replace the washer and and little metal threaded connected that connects to the waste and the bar. Instead of replacing the hole waste?
  16. C

    hansgrohe tap cartridge swap

    Is swapping the cartridges in these similar to a normal tap cartridge?
  17. C

    Small leak compression

    What would be the best way of fixing this leak it doesn't drip just builds up like that after a day of the water being on. Thanks. Guessing it's on where the olive meets the pipe and the nut as opposed to the olive and valve body.
  18. C

    Heat proof cable

    Is this 0.75mm flex heat resistant? I don't think it is. Thanks
  19. C

    Swapping trap on double bowl connector

    Is it possible to swap the p trap on a double bowl connector for a anti vac one?
  20. C

    32mm to 22mm reducer

    Can these go into the top of a waterless traps inline adapter or are the rubber push fit 32mm to 22mm reducers better.
Back
Top