Search results

thanks

ok thanks but what about the next fitting which might only be 6 inches away and the flux has started melting. would you carry on or would you reapply flux

hi im changing two 22mm water pipes over to an opposite wall. once I've joined the pipes with fittings and flux how long can I leave it before I solder and if where im soldering one joint the heat from the pipe starts to melt the flux on another joint will it still be ok to carry on and...

DONE IT!!! Thanks ever so much for your help and patience. A lot of people on here are very condescending and are very sarcastic in there answers. Great to know some of you actually want to help. Best advisor ive dealt with.

Ive just changed blue wire to terminal 2. Switched on hw and the motorised valve moved but pump did not turn on. So next step is yellow wire ( unofficially) to switched live to boiler did you say. How will i know which one that is

ok i'll look through it . the yellow/green wire isn't wired at either end

ok. so would you be able to tale me through the wiring from stat to terminals. for a start is the wiring in the stat correct, if not what goes where and do I need to connect the yellow wire to one of those terminals. I don't know how it could've gone so wrong

I have a Drayton mid position valve

Apparently was told earth did not have to be connected

Yes blue wire in with grey wire from valve

But the cylinder stat comes already wired doesnt it?

Im sure stat has been changed before. So maybe wired wrong

Thanks just tried turning cylinder stat back, as I did got to about 30/40 and heard the motorised valve move. started turning up slowly heard click but nothing happened

Hello I have recently changed my 3 port valve because I was not getting any hot water via central heating, I had to use immersion only. I assumed it was the valve stuck in heating position only as the manual lever on the valve was floppy and not doing anything. it was quite old valve and...

hi i have drained down a pressurised heating system until no more water came through and noticed that the pressure gauge had not dropped. i did the job knowing there was no water in the system. when i went to refill iturned it on and off quickly and the needle went right down to zero. so i...

Can anyone tell me type of primer to use for tiling over tiles Thanks

also I will be tiling my bathroom over the top of the old ones. the tiles are all even and tightly fitted. my question is what primer can anyone recommend or do I even need a primer ?

hello im going to tile a brick bbq, but need some advice on wether it needs some kind of primer or heat resistant paint and the adhesive that I should use. thanks for any replies

one more thing. When I filled the system should I have had the zone valve on manual. I didn't do anything with that.