Search results

Hi, it is: Texecom KIT-0086 Premier Elite 64-W Ricochet 64 Zone Wireless Alarm Kit with Wired Keypad I bought a Wireless as I though the screen would be the same and I could just swap that, it looks the same, lights up ok but doesn’t display anything.

Hi, I have an already installed Texecom Premier Elite alarm, the screen on the wired keypad got smashed. I bought a new (used) one on eBay, upon turning it on, it asks if you want to connect to the ricochet network, when you press tick if searches for 30 seconds then says it can’t find a...

Yes, I think you are right. What are the plastic pins in the top for do you think?

Hi, the top looks similar to the side where the hinges are, there are plastic pegs(?) every 200mm or so though?

Evening, we have a broken window on our front door. I'm not sure if the glass can be removed or whether I need to replace the whole door? What looks like beading, isn't beading. I've taken the door out and it doesn't come out that way? Any idea's?

Hi, yes that was it. It was set to Guard Access rather than Entry / Exit 1. Thanks!

Hi, I have just fitted a Texecom Premier Elite 64--W with 2x PIR and 1x Door Contact in my garage. The door contact is setup as OMISSABLE / ACCESS & ENTRY / EXIT 2. When the door is opened the alarm is set off immediately. It is also set to Timed, but it makes no difference. Thanks.

Ok, thanks!

So this would fit it? http://www.ebay.co.uk/itm/IMMERSION-HEATER-BIO-DIESEL-FUEL-PROCESSOR-FLANGE-NUT-/111564325197?pt=UK_Home_Garden_Hearing_Cooling_Air&hash=item19f9c0814d

Is it 2.25" BSP ? I've just found some cheap flanges on eBay that would save a lot of time if they are the correct thread!

Hi, does any know the thread type, minor diameter and pitch of the thread on the heating elements that screw into a central heating cylinder? I need to make a email fitting for one to screw into. Thanks,

That's what I did! Thanks.

I'm finally rendering the outside of my pond wall. It is made of hollow (figure of eight) blocks. Should I use PVA to seal the wall first? Or just wet the wall and start rendering? Thanks,

I got one today from PTS thanks. £15.69 though! It was leadline not leadloc.

What's the best lead pipe to 15mm copper pipe adaptor / coupling to buy. I've used one of the ones from Screwfix and it keeps leaking! Thanks.

Not particularly good. With the 7mm reccomended hole it wouldn't go in, the cross head was rounding but with a 8mm drill it was too loose. I went with some large 10mm normal wall plugs in the end.

Just usual 90 degree brackets. It been up for years but I tripped the other day and landed on it!

I've just bought some of these thanks: http://www.ebay.co.uk/itm/Rawl-Plugs-Thermal-Blocks-Fixings-x30-Plasplugs-Screws-/111005111864?pt=UK_DIY_Material_Nails_Fixing_MJ&hash=item19d86b9638&_uhb=1

I have a thermalite block wall that I want to fit a heavyish Oak shelf onto. What's the best fixings to use? Long wall plugs? Thanks.

Excellent, thanks very much.