Search results

Two different figures appeared when I checked it online - £36p.a. and £72p.a. try refreshing the page or logging again, perhaps the cheaper one will appear!

Perfect thanks. Thats what I was missing. Much appreciated. And it's not in the Panel User Manual...

As stated above, you don't get the keyfob manual in a kit box. The Install and Programming manuals only cover the panel, not the buttons or internals of the keyfob. Regards TT

You're right - there was nothing in the kit. So can anyone tell me how to do it? Thanks TT

Yes tried that but the F-ing manual doesn't show it, and I don't have access to an installers manual. But thank you for your very constructive and helpful advice, it is greatly appreciated. I will look to this forum first next time I need some help. Not. TT

Hi can anyone advise how to reprogram an existing Pyronix keyfob to a new Enforcer panel? The keyfob is one of the new type, rectangular (not square) with the four buttones one above the other. I've tried removing the battery to no avail. many thanks TT

Fair enough on the price, but that's not the point - where does it say that the service is only for one year? TT

Just an update for anyone following this - Pyronix sent out a new panel very quickly with software revision 2.01a installed, but it still didn't work first time. It turns out the panel needs to be power cycled to get the polling to kick in, following which it connected first time. Got there at...

Pyronix support by email has been very good, but so far no mention of a known bug. I can show that my PC can ping their servers, so I have just responsed to say that I think the problem is in the panel. Let's see what theynsay next. many thanks TT

Hi - I have installed a Pyronix Homecontrol+ with LAN card, and set the App and Network to poll the Pyronix Cloud. The Diagnostics are showing the correct Gateway and it has a valid IP address, so it is at least connect to the router. However, it also says that it has Never polled the cloud...

sorry moderator... (actually I hi-jacked it earlier in the thread than this! :-( current old fuse box has 6 x wire fuses, 2 x 5amp, 1 x 15amp and 3 x 30amp. don't really know what is needed but renter wants switched units not wire! thanks TT

What would be a guide price to replace my board with 6 x RCB's? We rent the house out and the young mother of one is unable to change the old fuse wire setup... cheers T

Hi The pins on my old fuse carriers are horizontal like this = but the ones on the MCB are vertical like this ¦ Does fitting the new shroud take care of this? thanks TT