Search results

Hi, I was hoping someone might be able to identify the controller in the photo and advise the best way forward : We have bought a ground floor maisonette circa 1970 and there are 4 rooms with these controllers in - estate agents said they control underfloor heating. There's no gas...

Hi, Really frustrated at the moment with bedroom painting - bubbles approx. 1-3mm in diameter appearing every time paint is applied. Hopefully the following will explain : I believe the wall to be fine as there were no bubble issues when first "finished" The paint is a Craig & Brown 1829...

Hi, We had some engineered wood flooring laid a couple of months ago in the hall which was squeaking a little but settling down ok. Then...........last week had a radiator leak overnight which I only noticed because said flooring was squelching when walked upon! Leak is now fixed however...

Hi, I need to install a metal light fitting in an upstairs bedroom which wouldn't be a problem as I have changed several so far and fitted the junction boxes, etc. as no scope for ceiling roses. However this fitting involves more wires than before and I wanted to check the best way to do...

Hi, I've noticed a purlin slipping its position in the loft and was looking for advice on the best way to repair. I first noticed a gap probably up to 5mm 6 months ago or so, but now reckon the gap is probably just over 1cm which is rather worrying! Is it something straightforward to do...

Hi, I've noticed a purlin slipping its position in the loft and was looking for advice on the best way to repair. I first noticed a gap probably up to 5mm 6 months ago or so, but now reckon the gap is probably just over 1cm which is rather worrying! Is it something straightforward to do...

Hi, From previous research I know that additional earth wires are advised when metal light switches and sockets are involved and that this is done by adding an extra earth wire from the metal switch/socket plate to the back box in the wall where there is (usually) a screw provided. Is this...

Hi, Currently stripping off wallpaper in our 70s house which is coming off ok but in places the old paint is peeling and can be ripped off in big chunks revealing the plaster. What's the best way to get a good paint finish when done stripping, i.e. primer everywhere/thin layer of filler in...

Hi, I'm putting some more insulation into the loft before boarding, however I have the previous run of ducting to remove first (pictures attached). I've taken a small amount apart to investigate but is there anything to be aware of, e.g. asbestos, any top tips and is the metal worth...

Hi, I want to put up a new landing light about a foot or so away from where its predecessor's ceiling rose was and have a dilemma as to the best way to reconnect power as the switch cable is too short for this new position and I also don't have a huge amount of slack on the light fitting's...

Hi, I've trawled many sites and can't seem to find an answer anywhere for my situation so I'm hoping someone can clarify for me : I need to put up a light fitting which will not work with a ceiling rose which is what is currently installed. The light is for downstairs and I know a good way...