Search results

Well I'm sorry but you have caused offence ! I thought these forums were help imPart knowledge to others not to slate them for not knowing . I'm sorry I obviously wasn't born with the immense amount of information about fault finding the YOU obviously were ! You only learn by being taught . I...

ok many thanks

Thanks ratonastick. i fitted the pcb as instructed on the paperwork . Was a little confused about the jumper connection. But going throught the actual boilers paperwork there is no fan transformer on this boiler. G.C 41-047-75. This is a British gas boiler rather than a standard glowworm. I...

And the point im trying to put across is that the pcb has been changed now and has cleared the f13 fault but after the start up of the boiler there is ignition but no combustion apart from a small puff of gas no full ignition.So was just asking for some advice to see whether someone else had...

I am gas safe registered . but am not a wise old sage like some people and so dont have all knowledge about everything. so you are permitted to to give advice if you so wish.

Hi im just after a little confirmation really . I had an f13 fault come up on this boiler ,checked all plugs and connections all ok so replaced the pcb , now im getting an f1 fault code, the boiler has a strong ignition spark and allows a small puff of gas through to the blast chamber but it...

Anyone please

Hi I wonder I'd you can help does anyone have any idea what the fault codes H & F mean on this boiler ? Thought it might be frozen condense but it runs internally to sink waste... Thanks in advance

thankyou kindly sir :)

ok what about the neutrals in No1 though

my bad .. yes three wires there is a wall stat , pump , 2 x 2 port valves, cylinder stat , boiler

fully pumped... pic is upside down

picture is upside down so numbers go right to left

bits

im changing a danfoss 3060 to a drayton lifestyle lp522 trying to follow the wiring diagram but i seem to have to many wires left over .. 1, No 1 neutral where does that go in the lp522 2, i have 2 live wires in No 5 ???? the diagram for the lp522 says all wires needed are E L N , hw on , ch...

try some one shot from b&q or plumbcentre if there is any blockage that'll clear it

yes tried that and it does .....

Thermostat clicks when turned up calls for heat but still continues to heat up when turned right down. i dont understand why the heat is still going round the system when boiler is swictched to HW only though

I am working on an Alpha cb 33 boiler and the CH comes on when only the HW switched on i have just replaced the diverter valve assembly because of a leak but the main problem still persists any help will be gratefully recieved