Search results

:P I have 4bedrooms what do you recommended as i'v been told 1 smoke head in each room and both hallways Thanks for all your replys

Thanks for the reply I have 7 smoke head and 1 carbon monoxide and 1 heat

Guy’s How do I wire up a smoke alarm in my house using the lighting circuit. I have 2 floors. Thanks

Thank you for that :)

Hi sorry fuse boards

Hi Guys Don't know if this has been covered before. Can you please help with advice? I wanted to know if there is any building regulations in commercial building that say about obstructing D.B Thanks

Hi, Im replacing my old HoneyWell T40 with a Honeywell CMT907A Battery powered thermostat. The T40 has 4 wires (Earth, live and two neutral from what i can make out) where the CMT907A only needs two. Ok I Have RED blue yellow earth. What cable on were on CMT907A

Hi all could I get advice me on the below whats the differents between led constant current driver and led constant voltage driver. I have led strips lights on a constant voltage driver, but when it's turned on it blinks every 5 ish min... Any one help me please

Thanks for your reply!! I have a Honeywell and will try that. Could that be the problem of the air in the system?? On CH Side

I have a Saunier Duval XEON 30HE Condensing boiler Open vent system. OSO unvented tank. The water works fine but the heating only works if hot water is also ON at the same time. On the Heating side when I bleed the RADs water come out but lots of air in all RADS. I have bleed all Rads...

Thanks for the reply guys I have a a in-line switch but how do i wire it up What cables gose were

Help needed Again :cry: I have a LED Strip light which will be on a 13amp plug top plug in to wall socket. But the Socket to difficult to acess on a day to day So I was thinking to put a 1way switch to turn the led's on and off from it HOW DO I WIRE IT UP :?

Help Me please Guys In my porch i have a ceiling rose lamp and wall switch. I would like to put in a ceiling PIr but can over ride it with the switch. step by step please and what cables go were, Thanks Guys :P

Ok thanks for that Guy's But there is only one cable in the old switch not two :?

Hi I have a Immersion hot water switch that need's replacing. I bought one at the back of the switch I have: Supply E,N,L and Load N,L,E. In which side do I conact the cable. The old switch dose not have same set up as new one Can someone please help me thanks

Ok Thanks for the link but im still confused :? new to all this

Hi Guy's I wanted to ask on how to wire up the below: I have a fluorescent light T5 for indoors and a two gang one way light switchand indoor and a outdoor flood light, the shed had its own DB HOw do I wire up, The flood light has Live(brown) and neutral(blue) Can some one please...

Hi I was looking for a little advice regarding wiring a fluorescent light into my attic. with a swich. :? There is a ceiling rose nere by that's for the 1st floor landing. I was thinking of using the ceiling rose to power the new one. I am using a 1.5mm cable but don't know what cables...

I have a saunier duval xeon 30HE boiler and Oso indirect. 2 bathroom in my house and kitchen. there is hot water at Oso tank but no hot water coming out the 2 bathrooms or kitchen. Only louk worm. But when I open Ground floor baysen hot tap and leave running there's hot water coming in...