Search results

Take trap off and push up with something from below

Yes you could extend the pressure relief pipe out through new roof

Hi is there a set number of noggins . timber is 9x3 5.2 m lengths 300 centers 5 m wide thanks

Would be nice and easy to upgrade to 15mm pipe work to rads with the floor up and give a better flow to the new rads

I would not wont lathe and plaster in shower area is a wet room or over bath etc

remove lathe and plaster put pipe work in the replace with aqua panel from wickes not plaster board you can tile straight on to panel

use some grips and turn bleed valve to open.Turn tap in then undo gland nut on valve the small on the spindle goes through and rap some ptf tape around it and do back up

could try looking for leak with inferred temp sensor in concrete floor mite show up some differences

first call out who ever fitted your boiler to sort it out

hi a copy of powerpoint fault-finding would be gratefully appreciated [email protected] thanks and a happy and prosperous new year

you should not need to change it if u have not had to keep topping boiler up or you have drained it down .you can buy test kits which tell u strength in system

hi have given g s number etc to forum but not verified yet as only done a couple of hours ago im sure your right about fault and im a muppet.Doing this to help mate out and realy pushed for time i havnt got and stress i dont need .

have down loaded mi but not very clear fault is saying purge gas witch is to valve and their is no fault chart to follow so if you have a clue it would help thanks

hi been to said boiler today the boiler was run for 8 months then drained down 5 or 6 years ago !! i filled up ch and hw turned on power nearly all workes got 21mb at inlet 0 at outlet sparks to try and light gas valve stuck i think have never stripped one down any ideas thanks