Search results

Via a keypad or fob?

The bell box tamper may fail for a fraction of a second which is enough to trigger the tamper fault on the panel.

See, I told you:)

I seem to remember these panels were rascal made by Guardall if that's any use. Of course I could be wrong (I've been wrong before according to my Mrs)

Remove the power, remove the battery. The bell/ siren may or may not sound but if it does it will either time out or run until the battery goes flat.

Are you sure it's the alarm that's beeping?

It should hold everything in the nvm so no need for any reprogramming. The link works for me by the way.

Omnicron 7000? If so power it down, move bell box, power it back up. here

Pull down white fuse holder. Remove fuse. Put in new fuse. Push fuse holder back in.

No, just program them as unused

i stand corrected :oops:

since when did the word OMIT look like a squinting eye?

i would not advise using a 7 amp hour with that panel, the charging circuit is not man enough to handle it!!! why not its's the same board thats in a full size accenta . :? and mines been fine for years on a 7 ah batt.

have a look here http://www.marshall-tufflex.com/shop/shopimages/sections/extras/Supertube.pdf

ericmark your right in your observation i work for n.g and their apprentices are nothing more than glorified labourers .i did three years on one hospital and the lad i was working with never touched a cable .thats three quarters of his apprenticeship .how are they expected to learn? edited...

if thats a guartec 300 i'll eat it :D

oh yeah, forgot about that bit :oops:

i seem to remember something about putting a link between set pos and pa and then powering up on accenta systems to default .don't know if it works with g3 /4 though its been a long time since i did it so dont shout if itdoesn't work

dont series the power :shock:

your welcome