Search results

thanks for the replies, I did get round to checking the pressure in the EV and it was flat/zero! I pumped it up to 1 bar (with the central heating circuit flat) and now its alot better, though the pressure can get up to 2.7/2.8 bar when radiators are on full and the hot water in use. According...

Hi, can anyone help i have problem with varying pressure for the CH on my baxi 105he. It goes above 3 bar and the PRV lifts and hot water dribbles outside through a vent. When the boiler is shutdown and allowed to cool the pressure can drop below 1 bar (to about 0.6) I have tried to re pressure...

Thanks for the above advice, I finally took the plunge and took the glass and bottom panel out and set it up useing the Toeing and heeling method,or at least my own novice variation. But it all went ok and now the door shuts nice. I would however advise anyone who is a novice like myself to...

Hi, I've just fitted a new UPVC door to my garage and had a bit of struggle getting it to close nice. i have since read a few topics on toe and heeling?, (wish I'd known about this before I started!) But if i can help I dont want to take the glass back out. I have already fitted the glass and...

viewed from the bottom

this is viewed from the top

Hinge pics

Thanks again for the advice static, hopefully I should get this little project completed in the next week.

thanks for the reply. When you say 600mm from the corner, I'm assuming you mean 600 from the inside/back of the garage front facing wall. ie looking at the internal picture. I was hoping it would be less as you can proberly see in the photo the further in over the door is fitted the more the...

hello, new to the forum.I'm Looking for some advice on a little DIY project that I'm looking to carry out in the next week. I'm looking to install a side access Upvc door on my detatched garage.I have purchased a 'L' lintel and ordered my upvc door. I'm fairly happy with the lintel installation...

from inside

from outside

Garage door