Search results

Hi, Thanks for the information. I did read the instructions for the RF2 and it seemed to fit what I was looking for. I was a bit worried that it days water or heating, but I suppose when it calls for heating it will heat our water up too due to the fact how our boiler is wired and works...

I have found this product, Sundial RF² Pack 2 Wireless Enabled Programmer and Thermostat, would this be more suitable?

I currently have a Baxi gas fire with back boiler that gives gravity hot water and pumped central heating. Can the Randall 102e5 that currently runs the system be replaced with a unit that has a wireless thermostat? (The options on the Randall are Water/Heating or Water Only) I have seen...

Hi, Thanks for the replies. bengasman - We don't currently have any room thermostat, that's why I was interesting in adding one onto the system and a wireless one seemed a good way to go. Also, I'm not sure we have a fully pumped system(?) I think it's gravity fed. DP - I think I...

Hi DP, Thanks again for the reply. At the moment, when the central heating is on, the water heats up too. So, for example, if we have it so it is set to Heating/Water, it heats both. If we have it on water only, just the water heats (except for 2 radiators upstairs!) So, for example, if...

Thanks DP. In that case then, doesn't it matter which wireless stat I use? Also, is the wireless stat 'base' wired in line with the current timer I have? So it goes something like: Boiler - Timer - Wireless stat base? And that the wireless stat base is wired into the points that...

Hi there, I have been searching these forums and the internet for a while, but I am still struggling to find the information I am looking for! I am looking into the possibility of having new rads installed on my central heating system complete with TRVs at some point in the future. What I...