Search results

Fitted a new blower motor to my Heatslave 20/25 as the bearings were shot, although the bearing noise is cured this motor is not as quiet as the original used to be, EOGB motor are they quality motors? Thanks

I have a poor multi layer emulsion on plaster job to remove, it's flaking away can get my scraper behind it in places. It's been put on layer after layer and no misting coat was applied. Reluctant to use my steam stripper as the heat blows the plaster skim off in places. Is there a good chemical...

Hello Just in the process of installing duct from an internal wall across the ceiling void to outside wall for a hob extractor hood. Method as follows I'm going with flexible from an under unit extractor through the cupboard then to manrose 204x60 rectangular duct up the wall to a right angle...

Wall mounted waterfall bath filler that is going to sit flush to my tiles, it is a solid unit with a male 1/2" G thread connection, do I leave a wall plate elbow recessed in the tiles and thread the whole thing into it using ptfe. If you have a look at Hudson and Reed code PN300 that's the one

Danfoss 071N0010 where is cheapest place to purchase online?

Worcester Heatslave 20/25 lockout What is my fault tree, oil supply is fine, whats next photocell? How do I check the oil solenoid and the oil pump are working

New house I have been given the user code but not the engineers code as the alarm was on contract and the company will not release the code to me but will come out and change it at a cost, yeah right. So as a qualified electrician I',m armed with my jumper link to do a power down reset to...

Securit 800l intruder alarm issue Set my alarm this morning, no issues, just got a call from father in law, called at the house (bear in mind its his first attempt at this) input the code within the entry time. When leaving the house he rang me to say he has an intermittent tone that will...

Securit 800l intruder alarm issue Set my alarm this morning, no issues, just got a call from father in law, called at the house (bear in mind its his first attempt at this) input the code within the entry time. When leaving the house he rang me to say he has an intermittent tone that will...

Looking for some dimmable downlighters (led) for the underside of my bedroom bridging units any ideas ?

The diverter valve on my Heatslave oil combi operates during the night when the room stat is not calling for heat, what else can cause the diverter valve motor head to power up and move the valve the pump doesnt start.

Bosch oil heatslave 20/26, my radiators are getting so hot you cannot touch them, room stat functions and controls the pump fine, I have changed the boiler's heating stat as you open and close the contacts with the dial the heater turns on and off, and it does operate at temperature but even...

As a qualified approved electrician due to redundancy I'm looking at the possibility of going self employed as a domestic installer, is it possible for me to do installation work and have it signed off by building control until i get registered with a part p agency