Search results

It all runs a lot smoother when you use a firm, problem with trying to run it with individual trades is getting them all in sync, they will all blame each other if there are any problems aswell. Where are you based?

Have just tried again

pm sent I think!

Hi frank, My email address is [email protected] I look forward to hearing from you.

Hi, where about in London are you? Would be happy to quote for you if you haven't already sorted it.

Got the dws780 myself and would highly recommend it, used the equivalent makita saw for the last couple of years aswell to compare it to and would rebuy the dewalt if anything happened to this one.

Finish nailer is not going to be man enough for stud work, job for a 1st fix gun rèally

Hi the reason the floor is not at the correct height is because the original extension was not set out correctly, now a 2nd storey has been added it now needs sorting, the floor will meet at a doorway and will be chipboard then carpet, so nothing visible. Any more information needed? Thanks

hi, I need to pack up some existing ceiling joists by 4" to meet with existing floor level on 1st floor. What is the best way of fixing 4x2 onto the 8x2s? Long screws straight down or can they just be toe nailed In place? Also would you run the 4x2 at 90 degrees to the existing joists or...

Hi all, looking for an extractor for site work and had been looking to get the festool midi, but now the fein dusted has caught my eye and looks good value. Has anyone used any of these or can recommend a different extractor?

Looking to pick up one of the above saws soon and wondering if anyone had used both and your opinions and if the festool is worth the extra £50 or so. would it be suitable for cutting/ripping timberboard? cheers.

if you really want an impact driver after you have bought a combi drill you could by a body only driver for around £75

I am in the process of building a timber framed summer house/office and need recommendations for the membrane. Am I right in saying it goes: P/board vapour barrier stud+insulation ply baton membrane cladding? Just looking for recommendations of what I can use as the membrane under the cladding.

Fix a corner post for the feather edge to run into, a piece of 3x2 or something.

Which would you guys recommend? Looking between the makita 5903 and hitachi c9u at the moment.

Sticks like sh*t should do the job nicely

Hi, have got oak veneer doors through out, unfortunately they were never finished when hung a couple of years ago so are looking a bit grubby. What's the best way to clean them off? Sugar soap? Once they are cleaned off what sort of oil or finish do people recommend? Thank you very much.

Nope. Literally just skewed nailed in to the joists. Only thing I could think was to stop them twisting.

Hi, can't see it supporting anything else, it's not set into the wall either. Is it there instead of noggins?

Hi I am about to install a new loft ladder but have a quick question about what I believe to be a binder? It is 4x2s running across the joists, one either side of the loft. I hope that makes sense. Can I cut this so that's loft ladder will fit or is it a case of choosing a new location?