Search results

I think its GRP. I'll take a look at doing a grp repair. many thanks.

Guttering works all fine and there is a proper drip edge. I've checked the windows and they are all ok. I don't think we have condensation problems. I'm a bit stumped.

I've been cleaning the inside of my downstairs bay window yesterday and found that rain water has managed to come through the bay ceiling and onto the window sill during the recent heavy rains. This has never happened before. Not a lot of water has come through. I've been up on the ladder...

I've got a number of door handles which have dropped. So decided to replace the springs. I've taken the handles off but not sure how to remove the cam. There are no circlips and the cam looks to be pressed in. Any ideas how to remove? I've tried to gentle prise off by no luck. See photos.

I've had a toilet leak in the bathroom which I've managed to fix. The floor has a vinyl floor laid on solid board. I had to take up all the vinyl up to sort out the toilet. Now going to relay the vinyl, but on closer inspection I've noticed that the vinyl floor has some rips around the toilet...

I've decided to replace an old bath front panel made out of a single piece of mdf with pvc tongue and grove cladding. I've cut all to the pieces to the correct dimensions and now faced trying to get all panels slotted in together. Problem I've faced with is trying to get all the panels pushed...

Yes the gap gives any water a chance from the sink to run down. It looks untidy and could prove a bit tricky to fill. I don’t know if it will continue to come away from the tiles.

I'm doing a spot of DIY in our bathroom. I've come across a problem with some skirting board behind the toilet and sink, it looks to have come away from the bathroom tiles. I don't quite know what to do. The gap is approx 6mm and runs for 30cms. If I try and remove the skirting (its looks to...

I've got 2 baths where the triangle shaped plastic trim has lots of mould around the silicone seal. Looks similar to the one in B and Q below. https://www.diy.com/departments/diall-white-pvc-self-adhesive-bath-seal-trim/1442957_BQ.prd?B/R_Tile_Trims_S_BSA_D I've tackled the 1 bath and cleaned...

Yes, the pipe insulation is approx. 25mm thick.

I’ve got copper pipes in the attic feeding 2 showers. There is extra thick pipe insulation around every pipe and the insulation is checked on a regular basis. Last week the pipes froze. They have never frozen before and we’ve been in the house 7 years. I know it’s been very cold but going...

Ok, thanks the showers are the instant type off mains cold. There are no electric pumps.

Many thanks for your advice. Sorry forgot to mention, there is no loft tank any more. The only pipes in the attic feed the showers. All the pipes have the modern thick insulation and where the pipes run along the attic floor they are also covered in loft insulation. We used to have a tank but...

My Wife went to use the upstairs shower today and found it was not working - just buzzing. I tried the second upstairs shower and the same, so I'm guessing the pipes are frozen. They are gravity fed pipes which go into the attic and down to 2 showers. They are lagged and I've never had a problem...

My old cistern overflow pipe has started to leak at the base. So trying to locate a spare rubber washer so far failed. I've been to umpteen local plumbers merchants and drawn a blank. The dimensions are 2mm deep, ID 26mm, OD 42mm. Any advice much appreciated.

Just had my worcester bosch cdi37 combi boiler issue fixed (intermittent problem with temperature of hot water - the heat exchanger was replaced under warranty). Next time the heating came on I noticed that the radiators were the hottest ever. They were dangerously hot. So I then checked the...

I checked the stack heights old vs new and they are both 13mm

So I've now removed the sash window. Put on the old hinges and measured how far the top of the hinge sticks out. I've made sure the new hinges matches the old ones. I've put the sash back into the window frame and now have the problem that the sash is approx 0.5cm more to one side of the window...

I've replaced my old hinges on 1 of my 16 year old uvpc windows. The hinges were showing signs of wear. The hinges were swapped over using the existing holes. Problem is I now have a an issue with a gap at the top between the sash and frame. In addition the window sash seems to be too much over...

Just started to prepare to paint a bedroom. Walls are plasterboard with emulsion. We've been in this 16 year old house around 4 years so guessing the paint has been up for around 5-6 years 2 of the 4 walls are going to be a different colour. So instead of cutting in as I usually do, I thought...