Search results

My guess is that if the gap is large when the door is shut then maybe the flooring is not level and when you open the door to a certain point it is tighter, this is down to the joists not being levelled properly. Only a guess though

A big self generating power wash, lots of brick acid, very long hoses, long reach bolster bars, big lances, lots of PPE, lots of method statements and risk assessments and the ability to be at 3 places at once and then have nothing the week after

Would one of the "new" fibreglass roofers not be able to do the whole roof and sides in grey to match?

Ask whoever is doing the roof, they will be able to do it cheapest as they are doing the reroof, they won't want to provide scaffolding and access/time for someone else to nip up while the roof is off

Sometimes you can knock a row of brick off at the bottom and the internal frame height is still higher than the internal finished floor height, this could gain a bit of leeway especially if the threshold is tall eg. More than 1 brick height, then maybe take some off the head of the frame to...

Once inside does the level of the floor step up again? I can't tell? :?

I have solved this before by cutting a square out of the floor in the area making noise, then noggin out where the square lines are cut to stop the new joints dipping, then glue and screw the trap back down using gorilla glue. While it is up if any metal straps are visible on top of the joists...

Check the felt/roof condition it those areas and all along top of garage door

I thought it was 2 degrees

Make sure you don't use any gas powered gear like a calorie gas heater! Co poisoning is a silent killer, are you drying clothes in the house? Do you have water under the floor boards? Water rises up sometimes. Do you have extractor fans in kitchen and wet rooms? Do you use them if so

Even on an integral garage?

^ agreed, they're a good frame too

Use a tile vent or go through a gable wall if available if you're not happy

Take the fixings out of the door and cut the sealant off, then wedge the frame up a bit and refix in new holes, if there's not much room to go up then take out the whole door and frame cut 10-15mm off the top then refit higher :mrgreen:

have you undone the right screw? :?

definately dont stand on in for a start, i would think about putting a wooden cross member half way down inside, because its sagging quite a bit. for a quick fix maybe 'flashband that joint from the top all the way down to the wall, and use that stuff around the pipe too :?

or chisel off the bottom inch of fascia first and the cover board will push up to the soffit

dummy sash to me

or go up the wall through the ceiling into attic then back down into desired room, dont take for granted the pipes are vertical from rad

the trouble is that there is no consistency with the quotes that people give because money can be hidden/saved in the materials and in the quality and time spent on each job. you cant beat an established local firm with reccomendations and just pay what they want to do the job properly. Ive...