Search results

  1. F

    Galaxy Flex siren not working.

    Can I clarify something regards connecting a dialler to the output module, I have 3 inputs on the dialler and I want to connect 3 triggers programmed intruder, pa and tamper. Is this possible and do i need to connect a resistor in series with the triggers.
  2. F

    Galaxy Flex siren not working.

    Must have been something like that nothing else to explain it. Many thanks for investigating for me.
  3. F

    Galaxy Flex siren not working.

    Hi yes wiring was connected as you say, when I first enabled the module the led did not illuminate. I reconnected the module and enabled again and now it works. Bit confused at what the issue was as the connections where as the instructions. Thanks for taking the time to look into this. Is...
  4. F

    Galaxy Flex siren not working.

    Thanks for you help much appreciated
  5. F

    Galaxy Flex siren not working.

    Im not by the panel but its a v3.37 if that helps
  6. F

    Galaxy Flex siren not working.

    Hi i have removed the module and connected the outputs direct to the panel and all works ok. I used the lead with the module connected red to 12v, black to 0v, and yellow and green to panel outputs 1 and 2. Then the bell and strobe to trigger module output 1 and 2 respectively. Sorry didnt take...
  7. F

    Galaxy Flex siren not working.

    I have also checked there is 14v present at the trigger module input but the led in the centre of the pcb is not active.
  8. F

    Galaxy Flex siren not working.

    Are the jumpers on the trigger module something maybe?
  9. F

    Galaxy Flex siren not working.

    Hi as instructed I have connected the bell wire direct to 0v and it sounds. The trigger module is enabled but under test in the panel nothing happens for bell or strobe
  10. F

    Galaxy Flex siren not working.

    Ok I will try tomorrow thanks for your help I will let you know the outcome
  11. F

    Galaxy Flex siren not working.

    Neither strobe or siren and the output polarity is set to neg as per siren manual
  12. F

    Galaxy Flex siren not working.

    Hi all, I have just installed a Galaxy Flex 20 panel which has a trigger module installed however the siren which is connected using op1 and op2 (bells and strobe) on the trigger module as per instructions and other cables connected to panel as normal (0v, 12v and T) the siren does not sound...
  13. F

    Galaxy Flex Ethernet Module port number.

    Hi i am using the virgin superhub 2
  14. F

    Galaxy Flex Ethernet Module port number.

    Can you give me a bit more info regarding how i port forward the different internal and external ports. I have a basic knowledge of networking. I understand it as forwarding 10002 to the second panel ip address and using selfmon with that one. I was going to use self mon anyway as the gx app is...
  15. F

    Galaxy Flex Ethernet Module port number.

    Hi all, Is it possible to change the port number of the ethernet module from 10001? I need to know as if so I will be using 2 Galaxy Flex systems on the same network and I cannot forward the same port to multiple ip addresses. Any help would be appreciated.
Back
Top