Search results

Hi all, I have a Pyronix Enforcer that I want to remove from my property. It is currently active but has no external bell. Can someone tell me how to power it down? Thanks

Hi, I need to replace the battery for my Pyronix wireless bell box. It was installed in Feb 2017 so I assume it's the old single battery replacement rather than double battery. Does anyone know? Would it be the ENF-BATT-RKP1 or BATT-CR34615D TIA

Hi, I currently have a Worcester Bosch boiler that is fitted with the integral diverter kit. I believe that the integral diverter kit needs to be removed before a Nest thermostat could be fitted is that correct and if so is it a lot of effort to remove? Thanks,

Hi, I have a Pyronix enforcer wireless alarm system which has been in place for one year. My alarm maintenance company want to charge 80 pounds plus VAT for the yearly inspection/test plus charge 5 pounds plus VAT to replace PIR / FOB batteries. This sounds a lot of money to me for a very...

Hi, Just over a year ago we had our en suite bathroom refurb’d and replaced the bath with a walk in shower - Truestone low level tray (all tiled in). The installation suffered numerous leaks which were fixed by the installer after several visits. A year on and we have discovered a brown patch...

hi, The chipboard flooring in my kitchen needs to be replaced due to flooding. The Howden kitchen base units that sit on top of the chipboard flooring including laminate worktop / sink etc will need to be pulled out so the floor can be replaced. My question is how likely is that the units extra...

Hi, We are replacing our floor in the kitchen / diner due to a flood and are wanted to have floor tiles (ceramic / porcelain). However we are worried our suspended floor isn't suitable. I've been advised that I could lay 18mm or 25 mm plywood before tiling but there is still a risk of movement...

Hi, I have 18-22 water flow rate. I measured the pressure on a garden tap at between 4-5 bars, dropping to 3.5 when I turned on the kitchen mains tap at the same time. I have a 17-18mm main pipe in and then I will be upgrading to 22mm to the cylinder. Does my property sound suitable for an...

Hi, I'm thinking of having an unvented cylinder installed. I know the flow rate is good over 20 litres per minute. I'm getting the pressure measured tomorrow. My question is on what size piping is sufficient to get good performance from showers and if changes need to be made. Mains into house...

Hi all, I'm having a Worcester Bosch boiler installed and all new radiators. The installer has recommended doing a Magna Cleanse system flush. Is this a sufficient clean of the system and likely to adhere to the terms of a manufacturer warranty (going to check this in the morning with WB)...

Hi I am having a new boiler and my old radiators replaced by new ones. Should the power flush be done with the old boiler and old radiators or is it better to remove the old rads (with sludge) and then do the power flush with the new boiler or old boiler (installer wants to do it with new rads...

Hi, I am looking at buying either the Stelrad Elite or softline radiators. Is there any difference between both other than look? I have noticed than the softline comes with a 15 year warranty. Thanks

hi, I am have a new boiler installed with a power flush and magnetic filter added. I have a couple of radiators that are currently cold at the bottom which I guess is due to the sludge in the system. The radiators are probably around 30 years old and I'm just thinking whether I should just...

Hi, I'm getting a system boiler installed and I need a new indirect hot water cylinder 1200 X 450. Any advice on which manufacturer to go for. Currently looking at a Gledhill. Thanks!

Hi, I'm looking at getting a new system boiler and have had 4 quotes but three different recommended size boilers, leaving me confused! I have a 4 bed house that has 10 Rads + 2 two heated towel rails. There are no plans to extend the house etc and to add rads. What size KW boiler do I need...

Hi, I'm about to get a new boiler installed and need to decide whether I should get TRVs installed, are they worth it?

Hi all, Has anyone had the Wave control system installed for their boiler if so I would be interested to hear feedback on what it is like as I'm thinking of getting it? TIA

Hi, I'm planning on replacing my 20 yr old heat only boiler and relocating it to the loft. I currently have 2 bathrooms but we rarely operate both showers at once. We have a water flow rate of over 22 litres a minute. I'm planning on changing the boiler to a Combi and either going to a...