Search results

Hi, I'm getting 14.3 volts, hoses are hot, coolant level ok, how easy is it to get at flap on heater Thanks

Thanks Peter I will try that and let you know.

Hi, I noticed the past couple of days that when my jeep is idle it's blowing out cold air but when i rev it or drive, it works fine by blowing out warm air !!! Any ideas ?

Hi Terry, Just letting you know that I bought a coil for the burner and installed it over the weekend and it seems to be working fine now (fingers crossed) i would like to thank yourself and everyone for there input into resolving this issue. Thanks again.

Just one more thing before I purchase the coil, why am I not getting 220volts on the spades that connect to the coil when the burner is called for Thanks

Hi, I know you did and appreciate your advice. I'll go and get a coil tomorrow. Thanks again

I always said it runs for a period and then drops out after two hours, if it is the coil why am I getting 2K at spade connections on coil and cable is fine, I'm very puzzled about this. Thanks for your time and input

Hi Terry, Coil seems fine measuring 2 k across parallel spades and cable is not broken, puzzled why I'm getting 70 volts at coil when burner is been called for and on a couple of occasions I was getting 220 volts even though I installed a new control box in which the connections from the coil...

Going to get oil pressure checked on Wednesday, I'll keep you informed Thanks for your time

Hi, I noticed this evening that boiler was on for 4 hours and then cut out again, left it off for 40 minutes and tried it again and it fired up no bother !!!

Thanks

Hi, Thanks for response Could you tell me what voltage I should be getting at the coil when burner is been called for as I seem to be only getting 70 volts Thanks

How do I check the oil pressure ? Thanks

Hi, Getting back to you with update: 1: I've changed the control box with brand new box 2: I've changed electrodes with brand new electrodes 3: I've changed photocell with brand new cell 4: I've changed oil nozzle with brand new nozzle Problem still seems to be there, I am getting sparks at...

Hi Terry, Sorry for only getting back now, I did a few more tests and results below: 1: when burner is switched on , I am only getting 68 volts ac across the solenoid and it's not opening now 2: removed the burner from boiler and electrodes are not sparking and also ceramic insulation is...

Thanks Terry for your input, I'll carry out a couple more tests tomorrow on it and get back to you Thanks again

Yeah the burner cuts out mid burn and locks out trying to re ignite, do you think a new control box would sort it out? Thanks

Sorry made a mistake, locks out restarting

Locks out restarting

Locks out at mid burn